Page: 16
J. Chime Feature K. Personal Attack from Keypad L. Fire Alarm From Keypad
The chime feature can be used on door contacts
to enable a ‘chime’ sound when a door (input) is
opened for example. It may be used on any input
on the system. This feature can be set up by your
installer.
To disable the chime on the keypad, close all
doors and when ‘c’ is displayed, press the
c
key, a capital ‘C’ will be displayed, this will then
activate the chime on any additional keypads
installed. If you wish to disable the chime
altogether press the c key again.
NOTE: If using wireless movement detectors on
the system it is not recommended to have chime
enabled for these detectors as this will drain the
battery.
If a PA alarm is needed, press and hold both the
1 and 7 keys or hold p for 3 seconds and a
‘PA’ alarm will be generated.
Note: The PA facility needs to be enabled by your
engineer (either silent or audible alarm option)
Please note that the keyfob can also be
programmed to support a PA alarm.
Please discuss this with your engineer.
If a fire alarm is needed, press and hold f for 3
seconds and a ‘fire’ alarm will be generated.
Note: The Fire alarm key need to be enabled by
your engineer.
To Next Page
Loading...
Need help?
General
