To Next Page

To Previous Page

Page: 9

F. Arming / Disarming the Tag Reader

If you have a tag reader installed, then it will be possible to arm and disarm the alarm system using a tag.

G. Open Doors / Arm and Disarm (Entry Control)

A tag reader can also be used to unlock entry doors.

External Tag Reader Instructions:

Arming: Present a valid tag to the reader, the GREEN LED will illuminate on the external reader, remove the tag, the door will unlock, then present the

same tag within 10 seconds and the system will arm and the door will lock.

Disarming: Present a valid tag to the reader and then remove it, the status will be shown (the alarm symbol will illuminate indicating that the system is

armed on the internal reader and the RED LED on the external reader). Present the same tag again within 10 seconds and the system will be disarmed,

and the door will unlock.

Access Control/Entry Control: The readers can be used also for opening doors only without the ability to arm and disarm. Please contact your installer

for more information on this feature.

NOTE: If the Enforcer has failed to set, a fault will be displayed on the internal tag

reader or a fail to set sound will activate on the external tag reader buzzer

Disarmed Armed

NOTE: If the Enforcer has failed to set, a fault will be displayed on the internal tag

reader or a fail to set sound will activate on the external tag reader buzzer

Disarmed Armed