© 1999 Directed Electronics, Inc. Vista, CA 37
To disarm VRS (before siren begins chirping):
1. Turn the ignition to the ON position.
2. Press the unlock button on the transmitter for 1 second. The parking lights will flash twice
and the siren will chirp twice to confirm that the VRS® system is disarmed.
To disarm VRS (after siren has begun chirping):
1. Turn the ignition to the ON position.
2. Press and release the Valet®/Program switch the selected number of times programmed in
Step 2-5. (See System Features Learn Routine section of this guide.)
NOTE: For a detailed explanation to the VRS triggered sequence, refer to the Vehicle Recovery
System section of the Owner's Guide.
rapid resume logic
The Rapid Resume Logic feature ensures that when the security system is powered back up after power has been
disconnected, the system will resume the same state it was in before power was lost. For example, if power is
disconnected during a full trigger sequence, the system will still be in the full trigger sequence when power is
reconnected to the unit. If power is disconnected while the unit is disarmed, it will still be disarmed when power
is restored. This also applies to the VRS sequence. If the unit loses power at any time during the VRS sequence,
it will automatically resume the VRS full trigger sequence when the unit is powered back up.
to disarm VRS
To Next Page
Loading...
Need help?
General
