© 1999 Directed Electronics, Inc. Vista, CA 7
IMPORTANT! When the vehicle is delivered, please show the user where this switch is located and
how to disarm the system with it.
Ensure that the location you pick for the switch has sufficient clearance to the rear. The switch should be well
hidden. It should be placed so passengers or stored items (such as in a glove box or center console) cannot acci-
dentally hit it. The switch fits into a
9
/32-inch hole.
This system has Remote Valet
®
. The user can enter and exit Valet
®
Mode without having to reach the
Valet
®
/Program switch. DEI introduced this feature so that switch location was less critical in day-to-day use. As
long as the Valet
®
/Program switch can be reached to disarm without a transmitter, easy access is not important.
Things to remember when positioning the Status LED:
■ It should be visible from both sides and the rear of the vehicle, if
possible.
■ It needs at least
1
/2" clearance to the rear.
■ It is easiest to use a small removable panel, such as a switch blank
or a dash bezel. Remove it before drilling your
9
/32" hole.
■ Use quick-disconnects near the LED wires if the panel is removable.
This lets mechanics or other installers remove the panel without cut-
ting the wires.
locations for the status LED
locations for valet/program switch
To Next Page
Loading...
Need help?
General
