33
© 2008 Directed Electronics. All rights reserved.
At this point you can either re-adjust the sensor or press or to save and
exit the programming. the siren will emit one long chirp when exiting the adjust-
ment mode.
The Impact Sensor Adjustment Mode exits if there is no activity from the remote
after 30 seconds.
Adjusting the impact sensor with the 1way companion remote.
Disarm system
Press/hold the button of the remote control for 8 seconds or until the Amber
LED turns on and you hear one long beep.
Press/hold the button 1.5 seconds or until the amber led comes on solid.
The control module emits one long chirp, confirming that it has entered adjust-
ment mode.
Press the , , or buttons to adjust the sensor level.
Arm button: Pressing the button increases the sensitivity one level. The siren
chirps twice confirming the sensitivity adjustment.
Disarm button: Pressing the button decreases the sensitivity one level. The
siren chirps once confirming the sensitivity adjustment.
Remote Start button: Pressing the button resets to default level 7. The siren
chirps three times.
To exit the shock sensor adjustment mode from the remote control:
Press and release the button any time during programming to go back to the
main menu. Press and hold for 1.5 seconds in the main menu to exit program-
ming.
To exit the shock sensor adjustment mode from the control module:
Open an entry point or turn on the ignition, the control module emits one long
chirp when exiting adjustment mode.
To Next Page
Loading...
Need help?
General
