44
© 2008 Directed Electronics. All rights reserved.
Feature descriptions
The features of the system are described below. Features that have additional
settings that can be selected only when programming with the Bitwriter® are
indicated by the following icon:
Note:
The numbers in parentheses indicate the number of times the LED on the
antenna flash. Default settings are in
bold
.
Menu 1 - Security
1-1 Active/Passive Arming:
Active arming (1
): When active arming is selected,
the system only arms when the transmitter is used.
Passive arming (2): When set to passive arming the system automatically arms
30 seconds after the last door is closed. To alert the user of passive arming, the
siren chirps 20 seconds after the door is closed. This provides the user with an
audible warning prior to the alarm actually arming. At the 30 second mark the
system arms, but without the siren chirp.
Passive arm & lock (3): When set to passive arming and locking, the system
arms the same as described above but also locks the doors at the 30 second
mark.
Auto re-arm w/o lock (4): When the alarm is disarmed from the remote a 30
second timer starts and rearms the alarm.
Auto re-arm w/lock (5): Works the same as above with the addition of locking
the doors when re-arming.
Note:
The re-arm feature exits when any hardwired input on the alarm is acti-
vated and does not re-engage until the alarm receives a disarm command from
the remote.
.
1-2 Panic On:
(
1 LED flash
) This feature controls whether or not the panic mode
is available with the ignition on. In some states there are laws prohibiting a
siren continually sounding in a moving vehicle. This feature makes the system
compliant with these regulations. The LED flashes twice (2) to indicate Panic with
ignition Off. When the Panic feature is Off, the LED flashes (3)
1-3 Arm/disarm and Warn Away CHIRPS ON: (
1
) This feature controls the
To Next Page
Loading...
Need help?
General
