55
© 2008 Directed Electronics. All rights reserved.
Long term event history
The system stores the last two full triggers in memory. These are not erasable.
Each time the unit sees a full trigger, the older of the two triggers in memory is
replaced by the new trigger. To access long term event history:
1. With the ignition off, press and hold the Valet/Program
switch.
2. Turn on the ignition.
3. Release the Valet/Program switch.
4. Press and release the Valet/Program switch within 5
seconds. The LED flashes in groups indicating the last two
zones that triggered the unit for one minute or until the igni-
tion is turned off. Refer to table of zones.
Note:
The Warn Away triggers are not stored to memory and is not reported.
To Next Page
Loading...
