22 23
PICTURE 4-20
PICTURE 4-21
STEP 3. Launch the eView app on
your mobile device. Log into
the app. This will take you to the
Management Window.
STEP 4. Tap the Add button. This is
located in the upper right corner of
the phone app. (Picture 4-20)
On tablets, this is the Plus (“+”)
button located in the bar under the
My Cameras tab. This is normally
hidden. To reveal, tap the arrow
(“>”) in the bar. (Picture 4-21)
PICTURE 4-22
PICTURE 4-23
PICTURE 4-24
PICTURE 4-25
PICTURE 4-26
Step 5. Enter the camera’s ID
number. You can either use the
keypad or click on the Scan QR
Code button to use your device’s
camera to enter the number
automatically.
If your device doesn’t have a
camera, the app will display an
error message if you attempt to
use the QR scanning function.
When scanning the QR code,
both the camera and your mobile
device will need to be relatively
steady. Laying the camera face
down on a surface can help. The
QR code does not need to fill the
white box on the screen. Your
device’s camera will automatically
adjust focus and the ideal distance
between your EasyView and your
mobile device is between 3 to 6
inches (7.5 to 15.5cm).
Once the camera’s ID is captured, click on Next in the upper right. If the camera is
unable to capture the camera ID, enter it manually into the ID area at the bottom
of the screen. Then tap on Next in the upper right of the screen to continue.
STEP 7. Select your connection
option. Choose the first option, Cable
Connection to proceed with wireless
setup.
In the future, if you are reconnect-
ing the camera to your network after
removing it from your account, you
may use the Already Configured
option to complete the process.
Tap
Next
to proceed
to the Camera
Status window.
This window will
show the status of your camera along
with its name, ID number and infor-
mation about its firmware (the inter-
nal software it uses to operate). Right
after connecting to your network, the
Status section may show as “Offline”
or “Unknown” as your app communi-
cates through your network with the
camera. The app will check to update
the status every five seconds. The
status should change to “Online” and
have green icon within 10 seconds.
STEP 6. Name your Camera. Once your
mobile device reads the QR Code, it
will show the ID number below the
Scan QR Code button. Tap
Next
to
proceed.
The next screen will display the
camera’s ID number and allow you
to name it. While you can pick a
generic name, if you plan on adding
more cameras or sharing this one, a unique name will help you - or those
you’re sharing with - easily select the right camera. You can only use letters,
numbers or the underscore “_”.
You can change the name later on the camera settings page.
To Next Page
Loading...
Need help?
General
