© 2018 QNAP Systems, Inc. All Rights Reserved. 17
The QES NAS management interface is now ready to use.
Setting up the ES NAS using DHCP
1. Run Qfinder Pro.
Qfinder automatically searches for QNAP NAS on your local network.
Note: The Qfinder client and NAS must be on the same subnet.
2. Locate the NAS with status “?”. This should be the new ES NAS. Confirm by checking the model
under “Device Type”.
Note: If both management ports and the Qfinder client PC are connected using a switch, then
Qfinder will also display a second device with status “?”. This is the IP of the second storage
controller and management port.
To Next Page
Loading...
