25
Chapter 6. Install and Hot-swap Hard Drives
The TES-x85U series is compatible with 2.5-inch/3.5-inch SAS and SATA hard drives. For
hard drive compatibility list, go to http://www.qnap.com/compatibility.
Caution:
QNAP is not responsible for product damage/malfunction or data loss due to misuse or
improper installation of hard disks.
Note when a hard drive is installed in a QNAP NAS for the first time, the hard drive will
be automatically formatted and all the data on disk will be cleared.
For information on QTS NAS migration, go to docs.qnap.com and check “Migrating from
Old NAS” section.
6.1 Hard Drive Bay Numbering
Identify the hard drive position in the diagram below.
1. TES-1885U (front) bay numbering:
2. TES-1885U (rear) bay numbering:
To Next Page
Loading...
Need help?
General
