Setting Up the NAS
1. Place your NAS device in an environment that meets the requirements.
For details, see Installation Requirements.
2. Verify that the intake vents on the bottom of the case are unobstructed.
3. Remove the protective films from the LCD panel and the front cover.
4. Install the drives.
For details, see the following topics:
• Installing 3.5-inch Hard Drives on 3.5-inch Trays
• Installing 2.5-inch Drives or Solid State Drives on 3.5-inch Trays
• Installing Solid State Drives on Solid State Drive Trays
5. Connect the power cord and all applicable cables.
6. Power on the NAS.
7. Install QTS.
For details, see QTS Installation.
8. Log on to QTS.
TS-1677X User Guide
Product Overview 12
To Next Page
Loading...
