20
To install or replace RAM modules:
1. Power off the system by pressing the power button for 1.5 seconds or until the system
beeps once. Wait for all the LEDs on the front of the system to turn off.
2. Disconnect the power cord, network cables, and any other cables attached to the
device.
3. Before opening the NAS, wear an antistatic wrist strap and connect the crocodile clamp
to ground to prevent electrostatic discharge from damaging equipment.
4. Remove the screws on the back of the NAS that are connecting the case cover to the
chassis.
5. Gently remove case cover from case.
To Next Page
Loading...
Need help?
General
