QNAP TS-1886XU-RP User Manual

3. Power on the expansion units.
4. Verify that the expansion units are recognized by the NAS.
a. Log on to QTS as administrator.
b. Go to Main Menu > Storage & Snapshots > Overview > System .
c. Verify that the expansion units are listed.
Connecting SATA JBOD Expansion Units
The TS-1886XU-RP supports a maximum of two SATA JBOD expansion units. To connect SATA JBOD
expansion units, a host bus adapter must be installed on the NAS. For details on the required accessories,
see Expansion Unit Installation.
1. Power off the NAS.
2. Install a host bus adapter on the PCIe slot.
Important
The QNAP QXP host bus adapter is required for connecting the SATA JBOD enclosure to a
host device. Third-party host bus adapters are not compatible with QNAP JBOD enclosures.
TS-1886XU-RP User Guide
Installation and Configuration 31

QNAP TS-1886XU-RP Specifications

General

Brand	QNAP
Model	TS-1886XU-RP
Category	Storage
Language	English