QNAP TS-1886XU-RP User Manual

For details, see Installing Expansion Cards.
3. Connect the expansion units to the NAS using the following topology.
Note
This image shows connecting the NAS to a TL-R400S and TL-R1200S-RP.
4. Power on the SATA JBOD expansion units.
5. Power on the NAS.
6. Verify that the expansion units are recognized by the NAS.
a. Log on to QTS as administrator.
b. Go to Main Menu > Storage & Snapshots > Overview > System .
c. Verify that the expansion units are listed.
Connecting USB Expansion Units
The TS-1886XU-RP supports a maximum of two USB expansion units.
1. Connect the expansion unit to the NAS.
a. Connect the USB cable to the USB Type-C port on the expansion unit.
b. Connect the USB cable to a USB Type-A port on the NAS.
TS-1886XU-RP User Guide
Installation and Configuration 32

QNAP TS-1886XU-RP Specifications

General

Brand	QNAP
Model	TS-1886XU-RP
Category	Storage
Language	English