LED Status Description
Drive activity Green The drive is ready
Flashes green The drive is being accessed
Off No drive has been detected.
Expansion unit Amber An expansion unit is connected.
Off No expansion units are connected.
10 Gigabit
Ethernet speed
Green The network connection is operating at 10Gbps.
Off There is no 10GbE network connection.
10 Gigabit
Ethernet activity
Amber A network connection has been established.
Flashes amber Data is being transmitted.
Off There is no network connection.
1 Gigabit
Ethernet speed
Green The network connection is opearating at 1Gbps.
Amber The network connection is opearating at 100 Mbps.
Off There is no network connection.
1 Gigabit
Ethernet activity
Green A network connection has been established.
Flashes green The network link is active.
Off There is no network connection.
Audio Alert
Duration Frequency Description
Short beep (0.5 seconds) 1 • The NAS is starting up.
• The NAS is shutting down (software shutdown).
• The user pressed the Reset button.
• The operating system was updated.
3 The user tried to copy the NAS data to the external
storage device from the front USB port, but the data
cannot be copied.
Long beep (1.5 seconds) 3 (every 5 minutes) The system fan is not functioning.
2 • The disk volume is about to reach its full
capacity.
• The disk volume has reached its full capacity.
• The drives are in degraded mode.
• The user started the drive rebuilding process.
• A drive is plugged in or out.
1 • The NAS was powered off by force shutdown
(hardware shutdown).
• The NAS was powered on successfully and is
ready.
TS-1886XU-RP User Guide
Basic Operations 39
To Next Page
Loading...
Need help?
General
