QNAP TS-855eU - Page 44

• For security purposes, the myQNAPcloud Link remote connection service will be disabled
on your NAS after initialization. You can enable it by connecting to QTS through LAN and
then installing myQNAPcloud Link.
7. Click Next.
The QNAP Warranty Service page opens in the default web browser.
8. Click Check warranty.
The QNAP Warranty Service window opens in a new web page.
Important
You can check your device warranty policy or purchase an extended warranty plan at QNAP
Warranty Service.
9. Close the warranty page.
The Smart Installation Guide opens in the default web browser.
10. If the screen shows a dierent operating system, click QTS.
Note
• This step is only required if the NAS supports installing more than one operating system
and the default operating system for installation is not QTS.
• If the screen shows QuTS hero, you may need to click Skip rst.
The NAS restarts and the smart installation screen shows QTS as the operating system to install.
11. Click Start Smart Installation.
12. Specify a rmware version using any of the following methods.
Methods User Actions
Current version Select Current version.
Latest available version a. Select Latest available version.
b. Click Check for Update
The system checks for the latest rmware update
available for your device. If a newer version is
available, the system downloads the rmware update
and restarts the NAS.
Uploaded version a. Select Uploaded version.
b. Click Browse.
The le upload window appears.
c. Select a rmware le.
13. Click Next.
The Enter the NAS name and administrator’s password screen appears.
14. Specify the following information.
• NAS Name: Specify a name with 1 to 14 characters. The name can contain letters (A to Z, a to z),
numbers (0 to 9), and hyphens (-), but cannot end with a hyphen.
TS-855eU User Guide
Installation and Conguration 43