11. Connect all cables and external attachments.
12. Connect the power cord to the electrical outlet.
13. Power on the device.
Hot-swapping Redundant Power Supply Units
NAS devices with redundant power supply units (PSUs) support hot-swapping.
Warning
The NAS may have one or more power supply unit (PSU) cords. To avoid serious injuries,
a trained service technician must disconnect all PSU cords before installing or replacing
system components.
1. Power off the NAS.
2. Disconnect the power cord from the electrical outlet and the power supply unit (PSU) that you are
replacing.
3. Firmly press the latch toward the handle and then pull the PSU out.
TS-x77XU User Guide
Installation and Configuration 27
To Next Page
Loading...
Need help?
General
