1. Verify that the NAS is powered off.
2. Connect the expansion unit to the NAS.
a. Connect the USB cable to a USB 3.2 Gen 2 Type-A port on the NAS.
b. Connect the USB cable to a USB Type-A port on the NAS.
3. Power on the expansion units.
4. Verify that the expansion units are recognized by the NAS.
a. Log on to QTS as administrator.
b. Go to Main Menu > Storage & Snapshots > Overview > System .
c. Verify that the expansion units are listed.
QTS Installation
The TS-x77XU uses the QNAP QTS operating system. You can install QTS using any of the following
methods.
Method Description Requirements
Qfinder Pro
installation
(Recommended)
If the NAS is connected to your local area
network, you can do the following:
• Locate the NAS using Qfinder Pro.
• Complete the steps in the Smart
Installation Guide wizard.
For details, see Installing QTS Using
Qfinder Pro.
• Computer
• Network cable
• Qfinder Pro installer
TS-x77XU User Guide
Installation and Configuration 33
To Next Page
Loading...
Need help?
General
