30
5.2 TS-x69U-RP/SP series (4/8/12-bay)
Follow the steps below to install a RAM module on the NAS.
1. Turn off the NAS. Disconnect the power adaptor, network cable(s), and any other
connectors or cables from the NAS.
2. Before installing the memory module, put on an antistatic wrist strap to prevent
electrostatic discharge. The crocodile clip should be connected to the ground.
3. Open the NAS.
a. TS-469U-RP/SP: Loosen the six screws on the top of the NAS.
b. TS-869U-RP and TS-1269U-RP: Loosen the two screws on the rear of the NAS.
To Next Page
Loading...
