10
CONFIGURATION
Login
1. Start your computer. Connect an Ethernet cable between your computer and the
Wireless Access Point.
2. Make sure your wired station is set to the same subnet as the Wireless Access Point,
i.e. 192.168.1.254
3. Start your WEB browser. In the Address box, enter the following:
HTTP://192.168.1.254
The configuration menu is divided into four categories: Status, Wireless, TCP/IP,
and Other settings. Click on the desired setup item to expand the page in the main
navigation page. The setup pages covered in this utility are described below.
No password required for the first login (the default setting), just enter the User
name 'admin' which is systematically fixed. Afterwards, you can assign a password
for a security consideration without changing the fixed user name.
To Next Page
Loading...
Need help?
General