11
Status
In this screen, you can see the current settings and status of this Access Point. You
can change settings by selecting specific tab described in below.
USystem
System
Uptime
The time period since the device was up.
Firmware Version
The current version of the firmware installed in this device.
Wireless Configuration
Wireless Mode
There are four modes supported, Access Point, Client (Ad-
hoc and Infrastructure), WDS Bridge and WDS repeater.
The default mode is Access Point. If you want to change to
bridge mode, please go to Wireless/WDS Setting to enable
the WDS function.
SSID
The SSID differentiates one WLAN from another, therefore,
all access points and all devices attempting to connect to a
specific WLAN must use the same SSID. It is case-sensitive
and must not exceed 32 characters. A device will not be
ermitted to
oin the BSS unless it can
rovide the uni
ue
To Next Page
Loading...
Need help?
General