QSC KC12 - Page 19

19
PRESETS (Inputs A and B ): Select a pre-programmed EQ and dynamic processing setting for specific applications.
• DEFAULT – No EQ or processing on the input
• VOX LO DYN – For lower-register performance vocals using a dynamic microphone
• VOX HI DYN – For higher-register performance vocals using a dynamic microphone
• VOX LO CON – For lower-register performance vocals using a condenser microphone
• VOX HI CON – For higher-register performance vocals using a condenser microphone
• HAND MIC – For speech intelligibility and feedback reduction using a hand-held microphone
• LAV MIC – For speech intelligibility and feedback reduction using a lavalier microphone
• HEAD MIC – For speech intelligibility and feedback reduction using a head microphone
• AC GUIT – For Acoustic Guitars with internal active or passive pickup systems
• E BASS – For bass instruments with active or passive pickup systems
• KEYS – For digital keyboards
• E DRUM – For electronic drum kits
• BAND MIC – For acoustic bands performing around a single condenser mic
• 100Hz HPF – For any input where a decrease in low-frequency is needed with a flat response
REVERB LEVEL: A single reverb is available with independent MIX controls available for both
channels A and B.
• Reverb (IN or OUT) – Select IN to activate reverb using the selected settings. Select OUT to
bypass the reverb settings and deactivate reverb.
• Reverb Mix (A and B) – The amount of reverb that can be added to the signal for both
channelsAandB,1-30
• Reverb Size - Selectable SMALL, MEDIUM, LARGE. (Reverb size is the same for both channels A and B.)
SUB LEVEL: Sets the subwoofer level, independent of the top box level. Using settings that increase the subwoofer level come with a
trade-off of sensitivity, so you may see LIMITER indication at lower volume levels when used in the Balanced setting.
• BALANCED – The subwoofer is balanced with the top box for optimal output before limiting.
• BOOST increases the subwoofer level for improved low-frequency support with program
material or electronic dance music.
• DEEP™ (Digital Extension and Excursion Processing) algorithm functions as a highly musical and
non-distorting low-frequency EQ circuit that gives maximum subwoofer level without
causing distortion or over-excursion.
• -1 to OFF – Allows the user to lower or turn off the subwoofer entirely if the application requires less low-frequency support.
• SUB ONLY – For use in subwoofer-only applications. This feature mutes the top box channel of the KC12 amplifier, so even with a
top-box plugged in, there will be no sound produced from the top box.
CONTOUR: Set a pre-programmed EQ and dynamic processing setting for the entire loudspeaker.
• DEFAULT – The standard voicing of the loudspeaker
• LIVE – For live sound reinforcement and vocal clarity
• DANCE – Low and high frequency emphasis
• CINEMA – Enhanced low-frequency reinforcement for portable cinema applications
FACTORY PRESET A
DEFAULT
VOX LO DYN
BACK
LOAD
VOX HI DYN
REVERB LEVEL
SMALL
A: 0 B: 0
MEDIUM
SET
LARGE
REVERB IN
SUB LEVEL
BOOST
DEEP
BALANCED
-1dB
-2dB
BACK
LOAD
SYSTEM CONTOUR
DEFAULT
DANCE
LIVE