in “Display” menu) and then press [ENTER] key. If the “STATUS” lamp of
DVR front panel is turned into green, it means you can use IR Remote
Controller to operate this DVR.
Stop using IR Remote Controller
When IR Remote Controller status is on, press [DEV] key again, the
“STATUS” lamp will be turned off. The IR Remote Controller can not
control this DVR.
Switch the DVR off
When IR Remote Controller status is on, press [POWER] key for several
seconds, the DVR will be powered off.
If the IR Remote Controller doesn’t work properly
z Check batteries poles.
z Check the remaining charge in the batteries.
z Check IR Remote Controller sensor is mask.
Please change another IR Remote Controller to try again. It the problem is
still existed, please contact your distributor.
To Next Page
Loading...
General