Display System Time
You can setup display properties for each camera, including display status,
position and format. Of course, you can copy the properties of one camera
to all cameras.
In “Image Setup” menu as following, select one camera:
Display mode: There are several display modes: Opaque&Steady,
Transparent&Steady, Transparent&Flashing, Opaque&Flashing, Move
“Active Frame” to “OSD” item, you can select one mode.
Display position and format: Move “Active Frame” to “Position” button
on the right side of “OSD”, press [ENTER] to enter into setup image, you
can find there are 22*18 (for NTSC, 22*15) small panes, and OSD
position is in red. You can use [È] [Ç] [Æ] [Å] keys to move the OSD
position.
Press [EDIT] key to select OSD format. There are following OSD
formats:
MM DD YYYY W hh:mm:ss (default)
MM DD YYYY hh:mm: ss
DD MM YYYY hh:mm:ss
YYYY MM DD W hh:mm:ss
YYYY MM DD hh:mm:ss
To Next Page
Loading...
General