Step 8: Motion alarm handle method setup: You can select one or
more handle methods such as “On Screen Warning”, “Audible
Warning”, “Upload to Center” and “Trigger Alarm Output”.
Description: If “On Screen Warning” is enabled, when there is motion
alarm happened and DVR is in preview mode, DVR will pop-up the
related camera. If you trigger more than one camera, DVR will pop-up
them one by one every 10 seconds. When the motion alarm is
disappeared, DVR will restore preview mode.
Step 9: Save motion alarm setup: Press “Confirm” button to return
“Image Setup” menu. In the “Image Setup” menu, press “Confirm”
button to save the current camera parameters.
Step 10: Save all cameras: You can repeat from step2 to step8 to
setup motion detection parameters for other cameras. Also you can
copy the parameters of one camera to any other cameras.
Note: Motion alarm area can not be copied.
If you want to disable motion alarm area and motion alarm policy, you
just need to select the motion alarm sensitivity as “Off”.
To Next Page
Loading...
General