Step 6: Motion alarm record channel setup: When there is motion
alarm happened, you can trigger related camera to start recording. In
“Motion Alarm Handle” menu, you can select one or more record
channels. Please use [ENTER] or [EDIT] key to enable the flag into
“9”.
Note: In order to make the cameras start recording, in “Recording”
menu, you must enable recording schedule and set “Rec Type” as
“Motion Detection” or “Motion | Alarm”. Please refer to chapter 5.12 for
recording setup.
Step 7: Motion alarm schedule: When the motion alarm is
happened in schedule, DVR will response such as “On Screen
Warning”, “Audible Warning”, “Upload to Center” and “Trigger Alarm
Output”. You can setup 4 time periods for one day and 7 days for one
week.
Note: Time periods in one day can not be repeated.
To Next Page
Loading...
General