Step 3: Enter into “Alarm in Handling” sub menu
In the “Alarms” menu, there are two options for “Alarm Handling”
item. One is “Ignore”, and the other is “Handle”. If you select “Handle”
option, you can active “Policy” and “PTZ Linkage” buttons on right
side. Move “Active Frame” to “Policy” button and press [ENTER] key,
you will enter into “Alarm in Handling” sub menu:
Step 4: Alarm trigger record channel setup
You can select channels to record for each alarm input. In the sub
menu, you can use [ENTER] or [EDIT] key to enable record channel.
“×” means disable and “9 means enable.
Note: In order to trigger the channel to record, in “Recording” menu,
you must enable recording and select record type as “Alarm” or other
related type. Please refer to chapter 5.12.
Step 5: Schedule for alarm handle method
When there is external alarm happened in the schedule, DVR will
response according to the handle methods.
Step 6: Alarm handle method
You can select one or more handle method: “On Screen Warning”,
“Audible Warning”, “Upload to Center” and “Trigger Alarm Output”.
To Next Page
Loading...
General