chapter 5.15 for sequence setup.
z Cruise: Set the flag as “9” to enable cruise. Please refer to chapter
5.15 for cruise setup.
Press “Confirm” button to save and return “Alarms” menu. Press
“Cancel” button or [ESC] key to abort and return “Alarms” menu.
Note: Please make sure that the PTZ you are using can support preset,
sequence and cruise functions. One external alarm input can trigger
many cameras PTZ linkage.
Step 9: Copy the parameters to other external alarm input
You can copy the parameters of current alarm input to other external
input.
Step 10: Save setup
In “Alarms” menu, press “Confirm” button to save the parameters.
Press “Cancel” button or [ESC] key to abort.
Alarm relay output setup
Step 1: In “Alarms” menu, use [Ç] [È] keys to select one alarm
output.
Step 2: Select delay time
The delay time is when the alarm disappeared; the alarm output will
continue output time. The delay time options are: 5 Seconds, 10
Seconds, 30 Seconds, 1 Minute, 2 Minutes, 5 Minutes, 10 Minutes and
Manual Stop. If you select “Manual’ option, the alarm output will not
stop until you press “Clear Alarm” button in “Utilities” menu. So the
actual alarm output time is made up of alarm input time and this delay
time.
Step 3: Enter into alarm out schedule
You can set the schedule to make alarm output into effective. Move
“Active Frame” to “Schedule” button on right side of “Alarm Out Time”
item, press [ENTER] key to enter into the corresponding schedule
menu:
To Next Page
Loading...
General