Initial Configuration
Quantum DXi4700 Installation Guide 63
l IP Address - The IP address of the DXi4700.
l Netmask - The network mask of the DXi4700.
l Gateway - The gateway of the DXi4700. (This is usually not the same as the default gateway.)
c. Select the Any check box to allow all traffic types (management, replication, and data) on the
interface.
d. Click Update to save the changes you made to the IP Address table.
11. Do not make any changes under IP Address Configuration > Routing Details unless directed by
your network administrator.
Note: If the DXi needs to communicate with another subnet that is not reachable using the default
gateway, a route must be added under the Routing Details section. (For more information about
interface routing, see the “Network” section in the Quantum DXi4700 User’s Guide, 6-68159).
12. Click Next to continue.
The Date & Time page displays (see Figure 49 below).
Figure 49: Getting Started Wizard: Date & Time
13. If necessary, select Manual Date & Time Settings to manually set the system date and time.
Specify the New System Date by clicking Calendar. Specify the New System Time using the drop-
down boxes.
To Next Page
Loading...
