EasyManuals Logo

Quantum DXi4700 Upgrade Guide

Quantum DXi4700
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #45 background imageLoading...
Page #45 background image
Turning On the System
Quantum DXi4700 Capacity Upgrade Guide 45
Turning On the System
To turn on the system:
1. Turn on the DXi4700 system components in the following order:
a. Turn on both power switches on the back of each Expansion module (see Figure 37 below). Wait
30 seconds for the Expansion modules to initialize. Verify on the front panel that the modules have
power and there were no hard drive failures (Drive status indicator on hard drive blinks amber four
times per second).
Figure 37: Expansion Module Power Switches
1 - Power Switches
b. Press the power button on the front of the Node (see Figure 38 below). Wait for the system to boot
before continuing with the procedure. (This can take up to 30 minutes.)
Note: The system may reboot one or more times depending on the components that were
installed. If all components are properly installed and cabled, the LEDs on all hard drives in the
Node and the Expansion modules will be lit. (The top LED will be solid and the bottom LED
will blink.)
Figure 38: Node Power Button
1 - Power Button

Other manuals for Quantum DXi4700

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Quantum DXi4700 and is the answer not in the manual?

Quantum DXi4700 Specifications

General IconGeneral
BrandQuantum
ModelDXi4700
CategoryStorage
LanguageEnglish

Related product manuals