EasyManuals Logo

Quantum LTO 1 User Manual

Quantum LTO 1
76 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
Chapter 1 Quick Start
Starting the Autoloader
LTO Ultrium 8-Slot Autoloader User’s Guide 5
Starting the Autoloader 1
To start the autoloader:
1 Attach the power cord to the autoloader, and then to the AC outlet.
For more information on power cords, see Power Specifications
on
page 50.
Figure 4 Attaching the
Power Cord and a
SCSI Terminator
2 Connect the SCSI cables and the terminator. For more information
about the SCSI interface, see Performance Specifications
on page 49.
Connect one end of the SCSI cable to one of the SCSI connectors
on the back of the autoloader.
Connect the other end of the SCSI cable to the SCSI connector on
the SCSI host bus adapter or on the previous device of the SCSI
bus.
If this is the last device in the SCSI chain, connect the SCSI
terminator to the remaining SCSI connector on the back of the
autoloader.
Table 1 SCSI ID
Default Settings
Autoloader 5
Tape drive 6
AC outletSCSI connectors

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Quantum LTO 1 and is the answer not in the manual?

Quantum LTO 1 Specifications

General IconGeneral
BrandQuantum
ModelLTO 1
CategoryStorage
LanguageEnglish

Related product manuals