Appendix A Specifications
Size and Weight
46 LTO Ultrium 8-Slot Autoloader User’s Guide
Size and Weight 1
SCSI Interface 1
The autoloader has a standard LVD SCSI interface. One SCSI cable and
one SCSI terminator are included with the autoloader. Additional cables
and terminators can be ordered from the manufacturer.
The LVD SCSI interface is compatible with a single-ended SCSI bus.
• Do not attach the autoloader to a non-LVD SCSI controller, as this
will degrade the performance of the tape drive and the performance
of your backups.
• Do not attach non-LVD SCSI devices to the same bus cable as your
autoloader, as this will degrade the performance of the tape drive
and the performance of your backups.
• Do not connect the tape drive to a disk RAID controller, as this is not
supported.
• If you are installing an adapter, it is recommended that you purchase
a SCSI LVD controller kit that includes a SCSI cable and SCSI
terminator (unless provided with your autoloader).
• It is strongly recommended that the autoloader not be attached to the
same SCSI bus as your SCSI hard drive(s).
Length
24.0 inches (60.9 cm)
Width 16.9 inches (42.9 cm)
Height 3.3 inches (8.4 cm)
Weight 19.5 pounds (8.8 kg) without cartridges installed
To Next Page
Loading...
Need help?
General