Chapter 3 Setting Up the Autoloader
Installing the Autoloader into a Rack
16 LTO Ultrium 8-Slot Autoloader User’s Guide
Installing the Autoloader into a Rack 3
The autoloader can be installed into a standard 19-inch rack.
Requirements 3
To install the autoloader into a rack, you will need the following:
• #2 PHILLIPS® screwdriver
• TORX T-10 screwdriver
• Rack mount kit — Make sure the rack-mount kit contains the
following items:
• Two support rails
• Two rack-mount brackets
•Ten screws
•Ten clip-nuts
To Next Page
Loading...
