Chapter 4 Operating the Autoloader
Menu Options
28 LTO Ultrium 8-Slot Autoloader User’s Guide
Menu Options 4
Figure 14 Autoloader
Menu Options
The menu options are accessed from the Operator’s Panel by pressing the
Enter button. Use the Previous and Next buttons to navigate through the
menu items. Use the
Cancel button to cancel the last action and return to
the previous menu item.
For most installations, the default configuration for the autoloader does
not need to be changed. However, if necessary, you can use the
Operator’s Panel to change the SCSI IDs for the autoloader and the tape
drive using the
Configuration menu.
Note: The autoloader and the tape drive must each have unique SCSI
IDs. It is your responsibility to make sure you do not assign
duplicate IDs within a bus. For more information on changing
SCSI IDs, see SCSI ID Settings
on page 47.
Commands Information Configuration Diagnostic
Import
Export
Load cartridge
Unload
cartridge
Clean drive
Re-Inventory
Cycle count
View event log
Product Rev.
Serial numbers
Firmware
revisions
Reset
Change SCSI
ID
Code update
Circular mode
Autoload mode
System test
To Next Page
Loading...
Need help?
General