Quantum Q-Logic 3 Programming Guide

36
Setting Up Reminders
Setting up reminders can be useful for medical reminders or
even service checkups.
1. Parameter Settings/Program Adjustments
2. Reminder
3. General Settings
 Display Time: Is how long the reminder will display
the screen.
 Repetition Rate: Is how often the reminder should
appear.
 Text 1-7: Up to 7 different text reminders can be
entered. Make sure when you type in each text box
to press enter when done.
Another feature in the Q-Logic 3 system is the Driven
Distance Reminder. This can be programmed to inform
an end user when it's time to contact their provider for
maintenance on their power chair.
1. Parameter Settings/Program Adjustments
2. Reminder
3. Driven Distance Reminder.
 Set Driven Distance Reminder to Enabled.
 Distance Reminder Text: Choose which text from
the General Settings page that will show on the
joystick.
 Driven Distance Trigger: Sets the distance that
should trigger the reminder to show up.
Day Reminders are used for reminders that are triggered
after so many days pass.
1. Parameter Settings/Program Adjustments
2. Reminder
3. System Day Reminder
 System Days Reminder: Set to Enabled.
 System Days Reminder Text: Choose the text that
will show up when the reminder is triggered. (Text is
from the General Settings page).
 System Days Trigger: Is to choose the number of
days until the reminder will trigger.
User Reminder Settings allows the user to turn off
reminders or postpone the reminder to later.
1. Parameter Settings/Program Adjustments
2. Reminder
3. User Reminder Settings
 User Has Access to User Reminder: Set to
Enabled. Allows the user to shut off the reminders.
 Remind Me Later set to Enabled: Allows the user
to postpone the reminder and it will pop up again
later.
REMINDERS
User Reminder 1 — 5 are used to set up specific reminders
in either Interval (every so many minutes the reminder will
pop up) or Time (that at that specific time the reminder will
pop up).
1. Parameter Settings/Program Adjustments
2. Reminder
3. User Reminder 1
4. Select the Type (Interval or Time)
5. Select the Text (Entered in under General Settings)
6. If Interval is selected, set the Interval time under
Interval.
7. If Time is selected, set the Start Time Hours, Start
Time Minutes, then Stop Time Hours and Start Time
Minutes.

Quantum Q-Logic 3 Specifications

General

Brand	Quantum
Model	Q-Logic 3
Category	Remote Control
Language	English