INSTALLATION
Harmony Ball Return Manual – 400-254-022 8 Rev. Date 3/16
6.2 HARMONY BALL LIFT INSTALLATION
See Figure 2 as a typical installation of a Harmony ball return on a 16’ [4877mm] approach with
the rack flush with the end of the approach. Note the differences in the possible bezel
supports used. Bezel supports with an open slot at the top should be used with a ball lift
installation depth of 14.5”. If the bezel support does not have an open slot at the top, the lift
should be installed at a depth of 14.25”
Figure 2, Standard Layout & Rack Bezel Support
16’ (192”) Approach
Used with 14.5” install depth.
Used with 14.25” install depth.
To Next Page
Loading...