GL300W Manage Tool User Guide
TRACGL300WMT001 - 19 -
Step_1: Select Command
Select command in Command Brower Windows basic on the function describes, after that the
parameters of the function show in Command Operation Space.
Step_2: Command Create Automatically
The command message which shall be sent to GL300W will be generated based on input and
displayed here. Please note this command message can also be sent to GL300W through SMS or
UMTS.
Step_3: Read Command from Device
It is recommended to read the parameters from GL300W and edit based on them.
Step_4: Set Parameter
Set parameters in Command Operation Space. Please refer to “GL300W @Track Air Interface
Protocol” for the meaning of each parameter.
Step_5: Send Command to Device
Click the “Send” button; download the parameters of this command to GL300W.
Note:
1. The parameters of GTSRI and GTBSI will be changed when change the parameters of
GTQSS.
3.3. Read/Save All Configuration
Step_1: It is recommended to read all configurations from device before saving the configuration.
Select “Read All Configuration””Read From Device”.
Step_2: After read successfully, click “Save All Configuration” in toolbar.
Step_3: Select a folder, and key in the name of configuration file, then click “Save” button.
To Next Page
Loading...
