Quectel BG96 TCP/IP

LPWA Module Series
BG96 TCP/IP Application Note
BG96_TCP/IP_Application_Note 22 / 52
2.2.9. AT+QISENDEX Send Hex String Data
The Write Command sends hex string data and cannot be applied for "UDP SERVICE" and "TCP
LISTENER" sockets.
Parameter
Default value: 1500. Unit: byte.
<read_actual_length> Integer type. Length of the data that has been actually retrieved. Unit: byte.
<remoteIP> String type. Remote IP address. It is only valid when <service_type> is "UDP
SERVICE".
<remote_port> Integer type. Remote port. It is only valid when <service_type> is "UDP
SERVICE".
<data> String type. Retrieved data.
<total_receive_length> Integer type. Total length of received data. Unit: byte.
<have_read_length> Integer type. Length of the data that has been retrieved. Unit: byte.
<unread_length> Integer type. Length of the data that has not been retrieved. Unit: byte.
AT+QISENDEX Send Hex String Data
Test Command
AT+QISENDEX=?
Response
+QISENDEX: (range of supported <connectID>s),<hex_string>
OK
Write Command
AT+QISENDEX=<connectID>,<h
ex_string>
Response
If the hex string data is sent successfully:
SEND OK
If the sending buffer is full:
SEND FAIL
If the connection does not exist:
ERROR
Maximum Response Time
120 s, determined by network.
Characteristics
/
<connectID> Integer type. Socket service index. Range: 0–11.
<hex_string> String type. Hex string data. The maximum length is 512 bytes.