LTE  Standard  Module  Series 
 
EG915U-EU_Hardware_Design                                                                                         16 / 81 
 
 
 
The following figure illustrates the pin assignment of the module.   
1.  USB_BOOT cannot be pulled up before the module startup. 
2.  Keep NC and RESERVED pins unconnected, all GND pins shall be connected to the ground. 
3.  The functions of pin 1 and pin 63 are under development and we do not recommend using them. 
4.  USIM2 is under development, not recommended for the time being. For details, please contact the 
technical support of remote communication.