Need help?Do you have a question about the Quectel RMU500-EK and is the answer not in the manual?
General| Brand | Quectel |
|---|---|
| Model | RMU500-EK |
| Category | Control Unit |
| Language | English |
Records changes made to the document over different versions.
Essential safety precautions for using the module and evaluation board.
Summarizes the main features and capabilities of the RMU500-EK evaluation board.
Illustrates the physical layout and location of key components on the evaluation board.
Provides a visual representation of the evaluation board's top surface.
Lists all the accessories provided with the RMU500-EK evaluation kit.
Describes the various interfaces and components available on the evaluation board.
Explains how to supply power to the EVB using different connectors.
Details the M.2 connector for module insertion on the RMU500-EK.
Describes the Type-C USB connector for host connection on the EVB.
Explains the 8-pin push-push (U)SIM card connector and its schematic.
Illustrates the pin assignment for the (U)SIM card connector.
Details the pin assignment and function for the (U)SIM card connector.
Explains the two status indicator LEDs (D104, D107) and their meanings.
Presents a typical reference design for the antennas.
Shows graphs of antenna efficiency across different frequency ranges.
Lists the specifications for each of the four antennas (Ant.0 to Ant.3).
Provides step-by-step instructions for assembling the RMU500-EK.
Step-by-step guide to powering on the RMU500-EK evaluation board.
How to establish communication between the EVB and a PC using the USB interface.
Procedures for upgrading the module's firmware using the QFlash tool.
Explains the hardware and software methods for powering down the module.
Lists external documents and resources relevant to the RMU500-EK.
Provides definitions for technical terms and abbreviations used in the guide.
To Next Page
