Smart Module Series
SG368Z_Series_Hardware_Design 114 / 113
3. A label with the following statements must be attached to the host end product:
This device contains FCC ID: XMR2023SG368ZWF
FCC/ISED Regulations restrict operation of this device to Indoor Use Only
4. Antenna Requirements:
• The following antennae were approved with the modules:
• The product is provided with an approved antenna. Use only supplied or approved antenna by
Quectel. Any changes or modifications to the Antenna may void the regulatory approvals obtained for
the product.
• Host device must comply with FCC Part 15 antenna requirements
• The OEM must design the host so that the antenna will be installed as an integrated antenna for the
host containing the SG368Z-WF and the end user shall not be able to access, remove or replace the
antenna.
5. This module must not transmit simultaneously with any other antenna or transmitter
6. The host end product must include a user manual that clearly defines operating requirements and
conditions that must be observed to ensure compliance with current FCC RF exposure guidelines.
For portable devices, in addition to the conditions 3 through 6 described above, a separate approval is
required to satisfy the SAR requirements of FCC Part 2.1093
If the device is used for other equipment that separate approval is required for all other operating
configurations, including portable configurations with respect to 2.1093 and different antenna
configurations.
For this device, OEM integrators must be provided with labeling instructions of finished products.
Please refer to KDB784748 D01 v07, section 8. Page 6/7 last two paragraphs:
A certified modular has the option to use a permanently affixed label, or an electronic label. For a
permanently affixed label, the module must be labeled with an FCC ID - Section 2.926 (see 2.2
Certification (labeling requirements) above). The OEM manual must provide clear instructions explaining
to the OEM the labeling requirements, options and OEM user manual instructions that are required (see
next paragraph).
For a host using a certified modular with a standard fixed label, if (1) the module’s FCC ID is not visible
when installed in the host, or (2) if the host is marketed so that end users do not have straightforward
commonly used methods for access to remove the module so that the FCC ID of the module is visible;
then an additional permanent label referring to the enclosed module: “Contains Transmitter Module FCC
ID: XMR2023SG368ZWF” or “Contains FCC ID: XMR2023SG368ZWF” must be used. The host OEM
user manual must also contain clear instructions on how end users can find and/or access the module
To Next Page
Loading...
Need help?
General
