Quick 9101 - Page 19

Ⅳ. Parameter setting and operation
16
“Cylinder Sensor interface”: Set the cylinder sensor parameter as “YES” or “NO” by pressing button
“Z”or “Z”.
If set as “YES”: it can use the sensor to judge whether the air cylinder arrives at the special position or not.
If set as “NO”: it doesn’t use the sensor and ignore the air cylinder whether it arrives at the special position.
Input4 is the inputting port of cylinder sensor.
When set “Input4:0”, namely, the low electrical level is effective: if Input4 is 0, the air cylinder arrives at the
special position.
When set “Input4:1”, namely, the high electrical level is effective: if Input4 is 1, the air cylinder arrives at the
special position.
“Start Key Work”: when pressing “START”key, it feeds or not. It can
set “YES”or “NO”by pressing button “Z”or
“Z”.
If set as “YES”, it starts to feed after pressing “START” key during work.
“Foot key”: pause or not when triggering “FOOT” key. It can set
“YES”or “NO”by pressing button “Z”or “Z”.
If set as “YES”, it can pause the processing after triggering “FOOT”
key.
If set as “NO”, it
cannot
pause the
processing after triggering “FOOT”
key.
Press “ENT”
Press “ENT”
Z-axis maximal range
Set the ports “Input1, Input2, Input3, Input4” as 1 (high electrical level) or 0(low electrical
level).
Press button “Z”or “Z” to set effective level as 1or 0.
For example: set input3 as effective level and it is connecting with a material detection
sensor, the unit starts to solder when detecting a workpiece, and it doesn’t solder when not
…
…
Press “ENT”
Press “ENT” button