Quick 9101 - Ⅰ. Safety Instruction

. Safety InstructionⅠ
1
. Safety InstructionⅠ
Caution: before using, please carefully read the following safety precautions. Store
the manuals in a safe, easily accessible place for future reference.
 Only use this robot with rated voltage and frequency (refer to the trademark in the back of
equipment).
 This machine is equipped with a 3-wires grounding plug and must be plugged into a 3-terminal
grounded socket. Do not modify plug or use an ungrounded power socket. If an extension cord
is necessary, use only a 3-wire extension cord that provides grounding.
 Don’t turn on the power of the machine when some parts are damaged, especially the power
cord is damaged.
 Don’t drop or shock intensively the unit for protecting it from damage.
 Don’t move the XY table and the top head of feeding solder controller.
 During processing, don’t touch the movable parts.
 Before using, check the heating controller and pressure reduction valve have been fasten
reliable.
 Keep the unit dry. Don’t use or disconnect the unit with wet hands.
 Check and clean the tubes at regular intervals for protecting the tubes to prevent clogging.
 Do the fittings change or maintain after turning off the power supply.
 Make sure the air supply is dry and clean. Select suitable air pressure according the component.
Suggest the air pressure is less than 0.7Mpa.
 During using, don’t over bend or revolve the PU tubes.