Quick GP2 2000 User Manual

GP Series
EN
QUICK GPSeries INSTALLATION AND USER’S MANUAL - REV000A
11
6 - Cautions & Use
6.2 - Use of the drum 1200/1500/2000
WARNING: before any warping operation, ensure that the anchor and its rope or chain are securely fastened to a
bollard or other strong point on the boat.
WARNING: during recovery, keep a suitable safety distance between your hands and the windlass drum.
1. Open the clutch with the lever (C), (at least 2 turns of the
bush (D) counter-clockwise).
2. Remove the lever from the bush (D), wind the rope over
the drum (at least 3 turns).
3. Activate the windlass control by keeping the rope under tension during the recovery. By varying this tension during
recovery, it is possible to change the winding speed of the rope.
X2
Min. 3 turns
C
C
D
D
6.3 - Troubleshooting
If the windlass stops and the hydraulic magnetic (or thermal magnetic) switch has not tripped, wait a few seconds and try again
(avoid keeping the button pressed). *ref. page 10
If the hydraulic magnetic switch, has tripped, reset it and wait a few minutes before weighing anchor once again.
If, after a number of attempts, the windlass is still blocked, we suggest to move the boat to release the anchor.

Quick GP2 2000 Specifications

General

Brand	Quick
Model	GP2 2000
Category	Marine Equipment
Language	English