What to do if my Quickie Xplore 2 Hybrid Wheelchair is not working?
If your Quickie Wheelchair is not working, here are a few things to check: * First, verify that the batteries are in the boxes. * Next, ensure that the power cable is properly connected. * Also, check the fuse and replace it if it's burned. * If these steps don't resolve the issue, the switchbox may be defective.
Why does the fuse keep burning in my Quickie Wheelchair?
If the fuse in your Quickie Wheelchair burns repeatedly, it could be due to a few reasons: * A mechanical restraint may be present, so verify the mechanical assembly thoroughly. * There might be a short circuit in one of the cables. In this case, call AmyPower Technical Support for further instructions. * The controller could be defective.
What to do if I hear the relays but the actuator doesn't operate on my Quickie Xplore 2 Hybrid?
If you hear the relays but the actuator doesn't operate on your Quickie Wheelchair, consider the following: * The actuator might not be connected to the controller, so verify the electrical assembly and programming thoroughly. * The actuator could be defective; if verifying the connection doesn't solve the issue, call AmyPower Technical Support for further assistance. * The controller itself might be defective.
Why is the actuator noisy when going up or down on my Quickie Xplore 2 Hybrid Wheelchair?
If the actuator on your Quickie Wheelchair is noisy when moving up or down, it could be due to: * A defective actuator. * A mechanical restraint. Make sure the seat is aligned well and doesn’t interfere with the rear of the tilt actuator when tilting. Check for and remove mechanical restraints. Eliminate all contacts of the actuator with the power base frame.
What to do if actuator only goes in one direction on Quickie Xplore 2 Hybrid?
If the actuator is only going in one direction on your Quickie Wheelchair (with DAC controller), it might be due to: * Wrong programming, so verify the electrical assembly and programming thoroughly. * Wrong cable plugging. If the problem persists, call AmyPower Technical Support for further instructions.
Critical safety advisory for wheelchair users operating the device.
Critical safety advisory for dealers and technicians servicing the chair.
Introduction to various warning categories within the manual.
Explains potential impacts of EMI on wheelchair operation and safety.
Identifies common sources of electromagnetic interference.
Instructions on how to report suspected EMI-related issues.
Essential safety guidelines for both wheelchair users and their attendants.
Information regarding the maximum weight capacity and its implications.
Guidance on adjusting and verifying controller settings for safety.
Pre-operation checklist to ensure the wheelchair is safe to use.
Warnings against unauthorized modifications and their consequences.
Safety precautions when the wheelchair is parked.
Guidelines for safely transporting the wheelchair in vehicles.
Explanation of factors affecting chair stability and tip-over risk.
Safety procedures and precautions for transferring in and out of the chair.
Specific safety precautions for operating the chair in reverse.
Safety precautions for handling and using the wheelchair batteries.
Explanation of motor lock function and safety during freewheel mode.
Safety warnings and operational guidelines for power seating features.
Details on the power recline feature, including pinch points and weight capacity.
Step-by-step instructions for removing and reinstalling batteries.
Instructions for installing, removing, and adjusting swing-away footrests.
Guidance on selecting and verifying optimal control settings.
Details on joystick connection to the controller and available types.
Instructions for engaging and disengaging motor locks for manual pushing.
How to operate power seating features using the joystick controls.
Standard operating instructions for the power tilt function.
Standard operating instructions for the power seat lift function.
Instructions for operating combined power tilt and seat lift features.
Standard operating instructions for the power recline function.
Instructions for operating power elevating legrests and center mount.
Standard operating instructions for manual recline adjustments.
Instructions for safely connecting and installing batteries.
Safety precautions and steps for charging wheelchair batteries.
Details on battery maintenance schedules and adding water.
General| Frame Type | Folding |
|---|---|
| Material | Aluminum |
| Footrest Style | Swing-away |
| Type | Hybrid |
| Weight Capacity | 300 lbs |
| Seat Width | 16, 18, 20 inches |
| Overall Length | 40 inches |
| Front Casters | 8 inches |
To Next Page
