EasyManua.ls Logo

Quicksilver 555 Pilothouse - Livewell;Raw Water Washdown (Optional)

Default Icon
53 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Quicksilver 555PH — System & Component Overview and Operaon
19
3. Livewell / Raw Water Washdown (oponal)
An oponal livewell and raw water washdown system is available for this boat. If installed, a 13 liter
livewell is located on the port a side of the cockpit, while the raw water washdown is located under
the starboard deck trail step. The livewell is used to keep baiish alive by circulang seawater through
the tank.
Livewell Operaon
Before operang the system, make sure that the livewell / raw water pickup valve is in the open
posion. The livewell / raw water pickup valve can be accessed through the motorwell access plate.
To ll the livewell, press the switch marked “LIVEWELL” on the sh pack switch panel located under
the port gunnel cap. Inside the livewell, there is an aerator spray head that allows you to control the
ow of water. To increase the ow of water, turn the spray head counterclockwise, while turning the
spray head clockwise decreases the ow. Located in the center of the livewell, there is a drain tube
which allows excess water to ow overboard, and fresh seawater to connually circulate. To drain the
livewell, simply unscrew the drain tube.
Check the funcon of all bilge pumps at regular intervals.
Clear pump inlet from debris.
The bilge pumping system is not designed for damage
control.
Livewell—Raw Water Washdown
Livewell/ raw water pickup valve
Livewell pump
Livewell tub
Livewell drain tube
Livewell drain thru hull
Raw water pump
In-line water lter
Raw water sprayer hose
Vented loop
Aerator
Livewell / raw water panel

Related product manuals