Quicksilver 555PH — System & Component Overview and Operaon
25
8. Engine Controls
Your boat comes with a mechanical gear shi/throle control unit, located to the starboard of the
steering wheel, which acvates both the shiing and throle for the engine.
To start the engine, the control unit must be in the NEUTRAL posion. When in neutral, the engine is
running, but the propeller is not spinning. There is a throle only buon that when pressed, will
allow you to operate the throle without the propeller spinning. On the mechanical shi controller,
the buon is located at the center of the throle control, and when moved back to the center
posion, the buon will automacally re-engage the shiing mechanism.
Power Trim & Tilt
The power trim, located on the side of the gear shi throle handle, allows you to raise and lower
the engine for trailering and launching the boat. It also allows you to adjust the engine to create the
opmum run angle for the boat to achieve best all around performance (fuel consumpon, speed).
REFER TO OWNER’S MANUAL PACKAGE FOR INSTRUCTIONS AND WARRANTY INFORMATION.
9. Emergency Engine Shutdown Switch
Your boat is equipped with an ignion shutdown safety switch built into the engine control. The
ignion shutdown switch incorporates a shut-o switch and a lanyard. Before operang the boat,
one end of the lanyard must be connected to the shut-o switch while the other end is connected to
the operator. If an emergency arises where the engine must be shut down, pull the lanyard cord to
release it from the shut-o switch, which in turn shuts down the engine. This switch is designed to
shut the engine o when the operator of the boat leaves the control staon, either accidently by
falling into the boat, or by being ejected overboard.
The lanyard should be long enough to prevent inadvertent acvaon. Do not let the lanyard become
entangled.
Hydraulic Steering
Steering wheel
Helm pump
Hydraulic uid ll
Steering hose
Steering cylinder
instrucons. The ll point is located on the helm itself, in front of the steering wheel.