Quicksilver 855WE — System & Component Overview and Operaon
54
27. L-Lounge Seang (oponal)
If installed, an oponal L-lounge seang conguraon is available to provide extra seang in the
cockpit. The L-lounge seang consists of a xed seat base with storage and a bridge seat located on
the port side of the cockpit.
A removable bridge seat between the a cockpit seat and xed seat base will create the L-lounge
seang. To install the seat, make sure that the cockpit seat is in the a posion. Next, set the base
between the xed seat base and the a cockpit seat and push down so that it engages with the rubber
stoppers. Now, aach the cushions to the seat bases and the backrest to the cockpit wall.
By liing the lever again and moving the a cockpit seat forward, you can rotate the backrest an
addional 60 degrees so that it lays at. With the oponal sun lounge conversion and L-lounge
conversion, the seat becomes a large area for sunbathing.
To return the backrest to it’s most upright posion, simply li the lever again and rotate the seat back
up.
26. Cockpit Table (oponal)
If equipped, a berglass cockpit table is available for entertaining. Included are two removable table
legs, which when not in use, are stored in the a cockpit seat. To install the table, rst remove the
plasc covers located in the table base plates. Next, push and lock the table legs into the base plates.
Finally, place the table onto the table legs. When not in use, the table can be placed in a convenient
bag and stored in the bilge.
Do NOT run the boat while the a cockpit seat is laying at.
Quicksilver® recommends that when the engine is running,
the seat back is in it’s most upright posion.
Before reclining the backrest so that it lays at, you must
move the cockpit seat forward. Failure to do so will cause
damage to the engine cowl and / or seat backrest.
Make sure the seat is locked in posion before using.
Failure to do could lead to injury.
Cockpit Table
Table bases
Table legs
Table
To Next Page
Loading...
Need help?
General
