Quicksilver 88688A26 - Electrical Connections

Electrical Connections
Failure to connect neutral start safety switch leads
properly could allow engine to start while in gear. If
engine starts while in gear, immediate boat movement
and a hazard to unseated occupants of boat or persons
and property outside of boat may result.
24982
a - Trailer Switch
b
- Trim Limit Leads
c
- 3-Pin Connector to Power Trim Harness
d
- Ignition Key Switch
e
- Neutral Start Lead from Engine Wiring Harness
f
- Neutral Start Safety Switch Connections
Connect Wires Together with
Screws and Hex Nuts, Apply
Liquld Neoprene to Connec-
tlons and Slide Rubber Sleeve
over Each Connectlon
IMPORTANT: When routing neutral start safety switch
harness, secure each harness every 18” (45.7cm). Be
sure that wiring does not rub or get pinched and that it
does not come in contact with water.
Outboard Models with Trim Pump Mounted Outside
the Boat (Between Engine Transom Brackets)
Outboard Models with Trim Pump Mounted in Boat
a - 3-Pin Connector (from Remote Control)
b
- Hose Clamp or Plastic Strap
c
- Bullet Connectors (Trim Limit Switch)
50128
MerCruiser Trim Pump
a - 3-Pin Connector
(from Remote Control)
b
- Hose Clamp or Plastic Strap
c
- Bullet Connectors
(Trim Limit Switch)
d
- Plastic Retainer
50128