R82 X:panda - x:panda Mounted on High-low:x

A
B
G
B
GB
X:PANDA MOUNTED
ON HIGH-LOW:X
To mount the seat:
The interface and the footrest bar must be
replaced on the old High-low frames.
Place the seat adapter in the interface and push
it all the way back, until it "clicks" into place.
Lock the red handle (B) to secure the stability
of the seat.
Do not use the first hole it „clicks” into. This
is just the „safety hole” which will „catch”
the seat if the knob accidently should pop
out of its correct hole.
To dismount the seat:
Unlock the red handle (B). Pull out the knob (A),
pull the seat forward, and lift at the same time.
18